边坡防护网在高速公路铁路滑坡中的使用，是保证边坡安全的一道保护网，边坡防护网在高速公路防护、矿山、堤坡所显示的作用越来越大。很多地方都安装了边坡防护网，高速公路、铁路两侧经常看见边坡防护网。可见边坡防护网的是保证自然环境、生命财产不可或缺的安全网。安装边坡防护网是具有挑战性的工作，特别是在高山、陡峭山坡上安装，难度非常大。今天我将经验分享给大家，一同探讨一下。
The
use of slope protection nets in highway and railway landslides is a
protective net to ensure slope safety. The role of slope protection nets
in highway protection, mining, and embankment slopes is becoming
increasingly important. Many places have installed slope protection
nets, and slope protection nets are often seen on both sides of highways
and railways. It can be seen that the slope protection net is an
indispensable safety net to ensure the natural environment, life and
property. Installing slope protection nets is a challenging task,
especially on high mountains and steep slopes, which is very difficult.
Today, I will share my experience with everyone and discuss it together.
1、安装边坡防护网前要清理山坡上的碎石、杂物等，清理工作非常重要，可以有效的保证工作的顺利进展。
1.
Before installing the slope protection net, it is important to clean
the gravel, debris, and other debris on the slope. Cleaning work is very
important and can effectively ensure the smooth progress of the work.
2、对于山体比较怪异的我们需要进行削坡。削坡的目的不仅利于边坡防护网的安装，而且能够很大程度上保证边坡防护网的牢固程度。
2.
We need to perform slope trimming for the peculiar mountain terrain.
The purpose of slope cutting is not only to facilitate the installation
of slope protection nets, but also to ensure the firmness of the slope
protection nets to a large extent.
3、安装边坡防护网锚杆是必不可少的。
3. Installing slope protection net anchor rods is essential.
锚杆的安装步骤：
Installation steps for anchor rods:
(1)选择根基比较牢固的地方钻孔，空的深度根据工程需要来定，一般根据猫版的尺寸来定，比锚杆的长度长出8mm左右，孔的直径不小于45毫米，空的大小直接决定了锚杆的牢固程度。
(1)
Choose a place with a relatively solid foundation for drilling, and the
depth of the hole is determined according to the engineering needs.
Generally, it is determined based on the size of the cat plate, which is
about 8mm longer than the length of the anchor rod. The diameter of the
hole is not less than 45 millimeters, and the size of the hole directly
determines the firmness of the anchor rod.
(2)钻后孔后需要安装锚杆并注浆，一般采用好的水泥与沙石，沙子与实惠的比例在1:1.1左右。
(2)
After drilling the hole, it is necessary to install anchor rods and
inject grout. Generally, good cement and sand are used, with a sand to
stone ratio of about 1:1.1.
